This 2002 Honda RS250R is ready to race and given the correct rider will take home a trophy.

This bike has been meticulously maintained and the engine has been built by Roland Cushway. Crank has been measured and balanced when installed. Pistons are measured and matched for proper height. Engine has 150 miles since being rebuilt and makes excellent power. All fluids are drained after each use for proper storage. Bike is kept in a climate controlled environment when not in use.

Bike Includes:

• Samba Exhaust system with Jha Titanium Silencers with custom adjustable mounts.
• Ti-Nitrad coated front fork sliders, tuned by Traxxion Dynamics.
• Ohlins steering damper.
• Penske 3-way rear shock with Titanium Spring, valved and tuned by Traxxion Dynamics.
• Brembo Billet Aluminum brake calipers front and rear.
• Custom machines aluminum rear brake caliper hanger
• Custom made lightweight, high pressure goodridge brake lines using Castrol SRF Fluid
• Custom machined Titanium brake caliper bolts.
• Battle Factory foot controls with Battle Factory Electronic quick shifter.
• Custom made exhaust manifold with O-rings
• Airtech RSW body work
• A-Kit (over the radiator intake) airbox
• Modified Radiator to accommodates A-Kit airbox

This bike has a large selection of new and low mile spares (almost all used spares have been pulled well before service interval limits).

Spares Package Includes: (for a complete list, click here: 2002 Honda RS250R Spares List

• 1 Front Upper Cowling - Used, some damage, repaired
• 2 Lower Cowlings - Used, some damage, repaired
• 2 Seat Cowlings - Used, in good condition
• 1 Sub-Frame - Used, in good condition
• 2 Wind Screens - 1 Used, 1 New
• 1 Air Box, OEM - Used, some damage, needs additional repairs but is useable as is
• 1 Radiator - Used, Modified for use with A-Kit Airbox
• 4 HRC Silencers - Used, some scratches and minor dings
• 1 HRC Exhaust Chambers - Used
• Large Selection of new/used fasteners/washers/grommets/etc..
• 8 Throttle Cables - 3 New, 5 Used
• 4 Clutch Cables - 2 New, 2 Used
• Large Selection of new/used bearings - Crank, Gear Box, Wheels, etc..
• Large Selection of Cranks Case Bolts, Cylinder Studs - Used
• Fairing Stay - New/Used
• Water Pump Gaskets - New
• Counter Shaft Gaskets - New
• Clutch Spring - New/Used
• Assorted O-Rings - New
• 2 Sets of Reed Cages - Used, Ported
• Full Set of Internal Gears with Shafts - Used
• Assorted Clutch Plates - New/Used
• 2 Outer Clutch Basket - Used
• 1 Internal Clutch Basket - Used
• 1 Complete Water Pump - Used
• 2 Water Pump Gaskets - New (many slightly used)
• Water pump seals - New
• Water Pump bearings - New
• 3 Cylinders - Used, 2 in excellent condition complete with power valves, 1 needs to be replaited/repaired
• 1 Set Brembo Cast Front Brake Calipers - Used
• 2 Honda Rear Calipers with Hangers - Used
• 3 Regina GP Chain - New
• Rear Wheel Adjuster - Used
• Sprocket Carrier Nuts - Used
• Assorted Power Valve Rebuild components (shafts, bearings) - New/Used
• Exhaust Manifold Gaskets - New/Used
• Brembo Front Brake Master Cylinder - Used/Damaged/Needs Rebuilding
• Brembo Brake Levers - Used/New
• Brembo Brake Master Cylinder Rebuild Kit
• Rear brake Master Cylinder - Used
• Assorted Brake Pads - Used
• Brake Caliper Mounting Bolts - Used
• Front Brake Lines, Stainless Steel - Used
• External Gearing - Used, 4 front, 6 rear
• Throttle Tube - Used
• Throttle Control Body - Used
• Clip On Bar - Carbon Fiber - Used
• Foot Controls, Stock - Used
• Battle Factory Foot Control Levers - Used
• Rear Shock, Stock - Used
• Assorted Fork Springs - Used
• Rear Spring - Used
• Shock Linkage Washers - Used
• Engine Mount Shim Kit - Used
• Top End Rebuild Kits - New 4 Pistons, Wrist Pins, Small End Bearings, circlips, O-Rings
• Reed Valve - Assorted, Carbon, Stock - Used
• Large Assortment Base Gaskets - Measured and sorted - New
• Reed Valve Gaskets - New
• 4 Cylinder Heads - 2 Excellent Shape, 1 repaired, 1 cracked
• 18 Used Pistons
• 4 New Pistons
• Spark Plugs - New/Used
• Reed Stuffers - 2 New, 2 used
• Jets - Complete Assortment of all jets/slides
• Stator
• Tachometer
• Temp Gauge
• PGM-II Unit
• Detonation Counter with Custom Mount
• Lap Timer Mount for Triple Tree
• Coils - Used
• Rear Rim/Brake Disc - White, Some nicks, Straight
• Front Rim/Brake Disc - White, Damaged can be repaired. Discs are straight and good condition

Package includes specialty tools from Honda as well as all needed tools to properly maintain this bike.

Additional Tools Include:

• Complete Service and Parts Manual
• HRC Tuning/Technical Notes
• Deck Height Gauge
• Custom leak down tester designed specifically for this bike (custom made block-offs for intakes)
• Engine Work Stand
• Front and rear battle factory race stands (front stand has been modified with the spindle floating on bearings to allow for turning the triple tree while on the stand)
• Wrench for adjusting rear shock
• Custom fuel tank drain shuttle
• Regina Master Link tool
• Clutch basket holder
• Spark plug cleaner (air/sand)
• Air Density Gauge
• Chicken Hawk GP250 Tire Warmers

This vehicle is available immediately. The price does not include shipping. Buyer pays all shipping and crating fees. I am willing to work with a buyer and deliver the vehicle to a shipper in the Atlanta Area (Forward Air, etc.). I am not willing to break spares package separately unless the buyer is only interested in the vehicle, then I will break and sell the spares separately

For larger images, click on the images below.