NSR250.net Forums Logo: Honda NSR 250 Forums, Classifieds and Service Manual in English. Covering All Honda NSR 250 MC16, MC18, MC21 and MC28 models
NSR250.net Forums

#
 
#
 
Performance Engineering

  • NSR250 Forums Index ‹
  • Members Content
  • Members Garage
  • Subscription
  • Transactions
  • FAQ
  • Search
  • Register
  • Log in

View Single Post


 Topic: Cylinder replating 







pbekkerh

 
    Send private message View user's profile
    Reply with quote

pbekkerh » Sat Apr 16, 2016 9:39 am

Make sure to specify whether the top an bottom surfaces should be "cleaned" or not. In the past, some companies have taken material off here and in that way changed the height of the cylinder and the compression ratio. Especially if it's been done several time, you might have to have special bottom gaskets made or use 2, to maintain the standard compression but the in- and out port will still have a slightly different timing.
Back to top

  • NSR250 Forums Index
  • All times are GMT
Powered by phpBB © 2001, 2005 phpBB Group


Hosted by NSR250dotNET © 2008 NSR250dotNET