In the processing of refurbishing two sets of SE/SP forks. Now, one of the fork internals has a defect. The very bottom of ot where you bolt it to the fork bottom with a bolt has come loose and it can turn and move up and down. Of cause this made it almost impossible to get the fork apart
I'we attached two pictures. One there end with the thread hole is in the "normal" position and one there i slid it to the lowest position possible, about 10mm down the tube.
Anyone ever seen this before?? Is there any cure or do I need to find a new/used one?
My first crazy thought was to give it 4 spot welds to keep it fixed, but don't know if that a good idea
Any help will be welcome!
Kind regards
Martin