So i´m still looking for the speedo cable, but it´s nowhere to be found for sale.
Tried ordering it from the site, you sent.
But 2 days after, i received an email, telling me, the order was canceled.
Speedo cable out of stock
Also i´m still not sure about my Air correction plumbing schematic. Some input there would be amazing.
Otherwise, i´m just going to have to test it. I just thought, surely, someone here must have better knowledge about it, than me.
Also i still can´t get the PGM-II to communicate with the MC16 Tacho.
Any input there would be amazing too.
I´m debating, programming an arduino to pick up rpm directly from the flywheel using a hall effect sensor.
Then i´d have to swap a servo into the MC16 tacho.
Would definetely like to go the more "stock-near" route, if possible.
Regards, Elias.