Little update on the work going on,
starting to put the fairing on and took me a few hours today to get the seat on, needed trimming down near the tank as the holes on the subframe where about 5 mm out, after fitting i noticed the harness can run along side the subfram which will be neater at the moment its underneath, but the seats on, and she's comming together, Not in the pic is my new rear master cylinder
CRF450 unit that was a bugger to fit also, a circlip here and one there and grind down the push rod and she fits nice, PHOTO to follow.
http://www.bikepics.com/pictures/502167/
http://www.bikepics.com/pictures/502170/