They were, for about a weekmick wrote:I thought your jets where big and gay enough to prevent a seizure Fontyyy.
But closer investigation reveals the cylinder (kindly "donated" by Steve) is marked L (SP) but it's only 86mm tall, SP barrels should be 86.5mm. Dodgy platers strike again, it's visably smaller than my other spare barrel (and thats an R!).
0.5mm is a lot of error, it'd actually only be .4 in situ as we used a .6mm gasket last time but that's still twice the "error" of using an SP head on an R barrel.
That, summer jetting and the cooler autum air would appear to have just been too much for it.
It gets worse, I even talked about this happening
How many of us check deck heights? Not me for one
Although Steve assures me this barrel could still have been OK if I'd jetted it right.
_________________
Please do not PM me technical questions, if you can't find it on the Forum start a thread
Last edited by fontyyy on Wed Nov 08, 2006 11:19 am; edited 1 time in total