aikawa wrote:I've been wokring on this damn clutch all day and cant get it to work.
I followed all diagrams, suggestions etc, but still no GO.

The bike only moves if I rev it up to like 7500-8000rpm, but then it still struggles, feels like i'm half clutching it the whole time when i'm not.

Need some suggestions!

Can`t remember on the NSR if the outer pressure plate has to mate with the centre in a certain way. Could be you need to move it round once on the spring mountings? (Rotate in either direction).
Also you haven`t just accidentally put two ball bearings in the pusher by any chance?
Check also that the lever on the left side of the engine is positioned correctly. The inner push rod shaft has to sit in the recess on the shaft of this lever.