I want to put a set of dymags onto a MC28. Now i think the rear hub is the same as an nc30/nc35, but im also told you can fit RS250 wheels to them as well.
The problem is, an RS250 wheel wont fit an NC30 because the 30 uses a flat washer under the wheel nut and has 4 drive pins and 4 bolts behind the wheel where on the RS250 it has the same 4 drive pins but no bolts. This means the RS rear wheel wouldnt sit as designed (as there is no room for the bolt heads). Also the RS250 uses a coned spacer to centralise (spelling) the rear wheel.

Anyone had any experance of any of this?

Cheers
_________________
If I have to take the carbs off once more...