I have just a couple of small queries I hope u guys can help clear up! First up at the front of the bike i have a small black connector that hasnt been used but that i suspect is for a kill switch. The bike came with no switches on the right handle bar - are there supposed to be some there and if so whats on them? Secondly, i have the PV servo bolted to the frame under the tank but it sits a little uncomfortably - is there supposed to be something under the bracket that would effectively raise it a little hence making it sit better? And also, having read all i could find on the site about setting the valves up i decided to leave that job to the pro's and start the engine without them hooked up to start with - is that ok or will it cause any damage? I started to fit the cables but found that that between the brackets on the cylinders and the pulleys the cables didnt even look straight? Lastly toward the rear of the loom there is an earth wire on the left hand side - where is that meant to bolt on the frame and will i have to scratch my paintwork off so it is in contact with the bare metal of the frame? Oh, and there is a wire on the underside of the pillion seat - where does that get bolted to?

Thankyou guys - by the way the bike is an mc18 (j2)