Ok thats interesting and slightly worrying! I wondered why my bike didnt appear to have a kill switch as i could see one on the sites wiring diagram! I have the headlight/indicators switches etc mounted to the left handlebar but it looks like there have been some subtle mods to the loom (although im probably wrong). The bracket that holds the front brake resorvior is home made and can only be pushed so far up the handlebar before the top yolk stops it. This leaves very little room for switches between that bracket and the throttle grip. There is a seperate section of loom about a 1.5 foot long which connects to a red connector block among the cluster infront of the PV servo which has two little female spade connectors and a bullet type connector which i guessed where for the front brake light and a kill switch as the bullet one has been crushed effectively making it useless. Could this be right? As far as i can tell i have connected everything else correctly and that only left the little black connector block which was beside two of the front indicator wires. I have taken some pics which i will try and add later on. Did anyone have any ideas on my other questions in particular the swinging bracket by the front sprocket?
Thanks all