Unfortunately Warwick, not everyone is as easy-going as you, and let's jut say "once bitten, twice shy"!

I'm not prepared to have to justify either my or the Forum's existence just because someone has taken exception to potentially damaging information a post or series of posts. Yes, misinformation can happen in a wide variety of subjects, but jetting is the most likely to cause more issues than any other subject, especially for those who shouldn't really even have a spanner in their hands, let alone a handful of brass!

I don't think it is unreasonable to ask those who are spending £400 on a set of chambers, and £150 on an HRC jet kit, to spend £50 at the dyno and have bike professionally set up if they don't know where to start. Once they have a good setup, it's a good base to fine tune if further changes are made.
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!