yeah there is on on the back of the kick start mechanism and it is present, there is also one on the front held in place by a circlip which is also present, this one wouldn;t even fit over the shaft anyhow,

So i'm left with two washers, a steel one and a plastic one, and only one visible place that needs one (water pump shim)

going off the manual, neither are the correct size, allthough i do think the plastic one had been used as the shim.

I'm removing them both anyhow.

After more looking and cleaning last night I also saw the 8x18mm gearbox plate locating dowel was missing, no biggie but makes life easier with it, discontinued part now so i'll make my own using the end of an 8mm drill bit.

Top end kit is now sat in the garage thanks Matt.