NSR250.net Forums Logo: Honda NSR 250 Forums, Classifieds and Service Manual in English. Covering All Honda NSR 250 MC16, MC18, MC21 and MC28 models
NSR250.net Forums

#
 
#
 
Performance Engineering

  • NSR250 Forums Index ‹
  • Members Content
  • Members Garage
  • Subscription
  • Transactions
  • FAQ
  • Search
  • Register
  • Log in

View Single Post


 Topic: Airbox holes: Where, why, and how large? 







jeff, OH

 
    Send private message View user's profile
    Reply with quote

Airbox holes: Where, why, and how large?

jeff, OH » Tue Jun 30, 2009 2:40 pm

Going to experiment with lidless vs. holey lid. Reading through the site, some put holes on top, some on sides, some cut off the whole rear of the airbox lid, some enlarge the stock hole locations, etc etc. General consensus seems to be that a holey lid is the way to go with two or four holes. Where are yours, and if you did it again, would you change the placement of them (other than duct taping over them)? Also, how large are the holes, and what differences did you make (or notice)?
TIA
Jeff
Back to top

  • NSR250 Forums Index
  • All times are GMT
Powered by phpBB © 2001, 2005 phpBB Group


Hosted by NSR250dotNET © 2008 NSR250dotNET