dld wrote:
At the base of the float bowl, the air mixture screw was seized and had rust filled in the hole. So i assume I should now set the screw to the default location,which is 13.7mm, found here
http://tech.nsr-world.com/nsr/nsr-all/carb-settings/

How do i measure this?

Er... that's the float bowl drain screw in the photo, and the float level measurement, not the air screw and its' setting!!

I think you should invest in a manual and some time in searching the forum!
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!