NSR250.net Forums Logo: Honda NSR 250 Forums, Classifieds and Service Manual in English. Covering All Honda NSR 250 MC16, MC18, MC21 and MC28 models
NSR250.net Forums

#
 
#
 
Performance Engineering

  • NSR250 Forums Index ‹
  • Members Content
  • Members Garage
  • Subscription
  • Transactions
  • FAQ
  • Search
  • Register
  • Log in

View Single Post


 Topic: What more can i do? 







Andy
Site Admin
 
    Send private message View user's profile
    Reply with quote

Andy » Wed Sep 30, 2009 12:33 am

Hey Pedro, congratulations on the podium finish!

Slicks will fit on the standard Magtek rims (if your racing class will allow it), but you will need to carefully set the suspension up to make the most of them as they will technically be over-sized, and this can ruin the handling unless done properly. Maybe look out for some RS250 NX5 HRC Magteks which will be the correct size for slicks? The rear will need to be fitted "back to front", but it doesn't matter.

As for easy* power, well that's difficult to say. If it's not been set up on the dyno then you may well find your HRC carded 28 is only making 58hp, in which case a good tweak of the carbs could liberate 3~5hp! On the other hand, it may be pretty much spot on already, and in that case you are going to find it very difficult to get any more than 62~63hp without getting inside the barrels and cases with a Dremel!

*62~63hp is the easy (if costly) bit on an MC28! Smile
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.


Check us out on Facebook! Please "like" our page!
Back to top

  • NSR250 Forums Index
  • All times are GMT
Powered by phpBB © 2001, 2005 phpBB Group


Hosted by NSR250dotNET © 2008 NSR250dotNET