my bike would not rev to redline in 5th or 6th.

so i assumed that the powervalves were not opening fully.

today i was adjusting my powervalves today using the guide.

they are now set up correctly.

but it made no difference, then i disconnected the powervalve servo in the hi position.

i took the bike for a spin and it ran fine but the midrange was terrible but in high rpm it pulled alot better.

i connected the servo again and i started the bike when in high rpm at around 10krpm i noticed that the servo is only half open.

is this normal???.

i am considering adjusting the powervalves to fully open when the servo is only half.