You can try a couple of things:

1. IGN off >> RUN switch off >>
   Turn servo pulley to about 2/3 open
   IGN on >> RUN switch on
   
   This should cycle the RC Valve back to closed. (You may need to kick the motor over to put some life into the IGN system with this method.)
   
   Or:
   
   
2. IGN off >> RUN switch off >>
   Disconnect the T.P.S.
   IGN on >> RUN switch on (valves should cycle to "Hi")
   RUN switch off >> IGN off
   Reconnect T.P.S.
   IGN on >> RUN switch on >> (RC Valves should cycle back to "Lo")
   
   And finally (mainly for the MC16 with no T.P.S., but works on all models):
   
   
3. Run the motor. Slowly raise the RPM from idle (1200rpm) to approx 2000rpm. At this point the servo should cycle to their "Hi" (open/setting) position. As the revs pass 3000rpm the servo should close again until approx 7000rpm.

_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!