Try this instead:

Fill the tank with a litre or two of pre-mix @ 30:1. Leave the oil pump in place, but disconnect the pipes to the inlets.

MAKE SURE YOU BLANK OFF THE UNIONS ON THE CARBS!

You can blank the unions off by looping a piece of pipe with a knot in it (or a small ball bearing pressed into it) between the two inlets.

Open the bleed screw on the pump to ensure 2T oil is flowing from the oil tank, then tighten the bleed bolt.

Fire the motor up on the pre-mix and watch the feed pipes until oil starts to drip from them. Once oil is coming out from the feed pipes stop the motor and drain out the premix.

Fill the tank with your normal fuel, refit the oil pipes to the carbs, and away you go!
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!