"I filled it with the tig welder..."

Novel!

Why not just "weld" a gas welding rod to it, heat the area up, and pull the dent out? Another, slightly cruder way, is to use a slide hammer and then seal the little hole back up with the tig.

Got the job done, but a bit Heath Robinson I think personally.
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!