2Tracelab wrote:

javes wrote:
{.bLanK}GoD: Is there any way to make the powervalves cycle again?

You can manually move the servo pulley near "hi" position (ignition switch closed please).
Turn ignition "on".
a) Pulley should go to "lo" on a well working unit.
b)Pulley goes around halfway (the exact position depends on the potentiometer tolerances inside the servo mechanism, but it's about there). Non - working and/or bad connection on TPS.
c) Pulley does not move at all. Rc valve section of the PGM unit is malfunctioning or PGM unit doesn't receive +12V or bad connections to ground.