Finally got it going and had a spin round the block, not quite right, spluttery at 3krpm and won't rev past 7500rpm but still got a buzz.
Can anyone assist with the spluttering? I have ERR3 on my dash and the warning light stays on. I think the RC valves are working
Just as it reaches 7krpm it surges but the servo doesn't move at low revs (at least it didn't when I was working with the tank off). If the servo isn't working would the spluttering come from the valves set incorrectly and could I fix this by setting them up? I might try that later but dark out now.
I did have an electrical problem (no front light) but that went as soon as I kicked the bike over
Cheers