nxrsr20 : I have powered the servo motor from down the loom at the 16pin connector end and the servo spins fine.

the only items that don't make sense withe th manual is the voltage output at the throttle sensor and saervo motor connectors. it was 6.82v on both and the manual says 4-5v.

Also in the manual it is a bit vague but says when i power the servo motor direct it should spin "opposite direction" I assume that is counter clockwise, mine just spins clockwise.

With CDI connected the throttle sensor has voltage and varies from .84-4.69v which is within range.

does that fact eliminate a potentially faulty CDI(PGM)Doesn't smell burnt either.

No NSR's within a few thousand kms to test on !!!!!

Thanks in advance for anyones help