Bonjour,

Trying to get my MC28 going for the early morning mountain ride tomorrow but can't get the RC valves to operate.

I've installed the new PGMIV (Moriwaki Man HRC spec, just back from Japan), I serviced the RC valves this morning and bought a new battery...I cannot get the RC valve servo to move and I have tried 3 different servos!

There is no ERR2 code. I do get the ERR3 when I disconnect the TPS.

Does the motor need to run in order to reset the servo? I haven't got the tank on yet so no fuel to get it running.

Swift help would be mucho aprreciato as it will be dark in a few hours!

Cheers
_________________
1996 MC28SE (Honda Flash), 24,000KM - Drilled airbox, HARC Pro pipes, TYGA Hi-flo reeds, special manifolds, Ohlins rear shock & steering damper - SOLD

1993 MC21SP (Winner's One), 10,000KM - Drilled airbox, wire splice - STOLEN!!!

1990 MC21SP (Cabin), 20,000KM - NC30 forks, discs, calipers - EN ROUTE...