ok so im down to just unbolting the motor. short upper aft bolt no problem thats out but im struggling with others. 1st the lower long aft bolt, ive removed the 14mm nut and thought the long bolt would just push through with the allen bolt being used to push the motor over and the large flat nut securing that. is this how it is because the long bolt/spindle wont budge and i cant budge the large flat nut but im not trying too much until i understand how its all assembled/disassembled. next is the forward mounts again removed the 14mm nut and rubber washer/spacer to be faced with a weird set up just past that looks like a spline so i dont know where to go from here. help please.
Andy dont know if ive got my wires crossed with the online manual but say a section goes from 19-1 to 19-6 i can only get 19-1 it then goes to 20 but this is on most sections. im expecting more detail but am i right to? am i doing something wrong?although the engine removal section is complete its very basic for removal basically just reading "remove bolts and lower", yes engines are just fixed in with nuts and bolts so am i just encountering stiff bolts/spindles or pussying around too much?
cheers, andy