Difficult to say as they are both very different bikes to ride, that's for sure. Only you can decide that one.

If I were in the States personally, I would send BOTH barrels to Eric Gorr and get a port job on them and a replate on the dead barrel! If the port job is half as good as the MC18 he did that I rode a couple of years ago, then you will have a cracking motor, and he is extremely well priced.

Paul "Wrench" Herr will set you straight on Eric Gorr.
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!