sennidott wrote:I have just had my RS cylinders replated by Aptec. I have not used them yet (ahem...*cough*) so cannot comment but they are 'round' and the piston / bore clearance is correct.

I've seized twice on a barrel plated by Aptec, both seizures were due to the ring pin hopping out and the end snagging in a port (so, not a plating issue), both times the plating survived intact as much as you could reasonably expect and the barrel was cleaned up and ran again that weekend.
No peeling of plating whatsoever, very happy with Aptec's plating.
_________________
Please do not PM me technical questions, if you can't find it on the Forum start a thread