i am putting the motor that came out of a NSR250 frame in a super kart frame, well the motor is aready in the kart frame. The bike frame has PGM-CDI unit with wiring harness and i did not want to use the PGM-CDI or harness, as at a later date I will restore the bike and in the meantime have some fun using my super kart with the NSR motor, is that clear so far?. i managed some time ago to aquire a PGM-II and harness and now relize that the harness wont fit the terminals on the motor. so do I need a stator and pickups to fit the PGM-II?. guess i do.
The RC servo terminals/connectors fit the PGM-11 harness so all good there i guess.
TPS sensor connector is different as is the air balance connector.
I would put up some photos but not figuered out how to do that yet on this site.
Any thoughts everyone
