I picked up my Yahoo Japan purchase while in Tokyo last week, had it posted to my hotel. A NSR single seat that looks like RichG's Rothman's NS400.

Now I have popped it on to the existing seat frame, just for a look.

I have noticed that the front lower section seems to fit and position on the frame pretty well, however if you look at the images the seat base is high compared to stock (I think).

Also the rear under-guard from the 18 seems to be a close fit.

Looks like it sits up a little high compared to the swing-arm and tire coverage.

Never having fitted a single seat cowling, I'd like your expert opinion of the correct process to do so? Where to start what not to cut, etc.

What suggestions do you guys have?

Neil (Merry Xmas)