Update time, so post compression test I have decided the motor will need a top end rebuild at minimum, so I dropped the motor. First port of call though is to do a leak down test, which I plan to do with a bicycle pump, and some bungs to plug everything up, hopefully this weekend...
The other night, I came across a guy here in Oz rebuilding an MC21 on a cbr forum, and he is doing a beautiful job, and so I was inspired. Once the engine was dropped, I pulled the rear subframe off, and basically went to town.
Basically this is what I finished up with this arvo.
This is a little bit funny, seeing as I have been a little depressed about the prospect of what seems to be an impossible task of a bottom end rebuild.
Now to clean all the parts up... I wanted to ask if anyone had any opinions/experiences about treating the frame and swing arm bearing in mind that I would like to keep the brushed look? anodising? powercoating etc...
I would also love to hear any other tips and tricks for parts cleaning is welcome as this is a first for me...
Thanks guys
Thanks