NSR250.net Forums Logo: Honda NSR 250 Forums, Classifieds and Service Manual in English. Covering All Honda NSR 250 MC16, MC18, MC21 and MC28 models
NSR250.net Forums

#
 
#
 
Performance Engineering

  • NSR250 Forums Index ‹
  • Members Content
  • Members Garage
  • Subscription
  • Transactions
  • FAQ
  • Search
  • Register
  • Log in

View Single Post


 Topic: Fueling issue: General help needed. 







das134
Supporter - Titanium
Supporter - Titanium
 
    Send private message View user's profile
    Reply with quote

das134 » Mon Feb 11, 2013 4:58 am

Satchriossi wrote:Do you mean the exhausts are actually full of fuel or do you just have wet pipe ends which drip a few spots of black 2T jizz?

My bike has always had wet pipe ends after a run and if you hold your hand in front of the exhaust whilst the engine ticks over you get wee black spits all over it after a while. Yet it still pulls to the redline etc etc. No wheelies though...

You wouldn't happen to be bringing it to Manfeild on Saturday would you?


I couldn't say if they were 'full' of fuel, but there is enough coming out the back that I need to wipe it up (I am pedantic though as you know). Plus it weeps out around a couple of the rivets in the end cans close to where they bolt on to the chambers. I have to wipe it up too. But yeah, it's not like its pouring out or anything. Sounds similar or slightly worse than what yours does.

But it didnt do that (that I can remember) before I put the new parts on. Or at least I'm pretty sure it didn't. And I exaggerate, it won't pull anything like a big wheelie, just a little lift in 1st and maybe 2nd.

Not going to Manfeild im afraid, have to work the saturday in Auckland and the drive would be a killer to get back sunday night...
Back to top

  • NSR250 Forums Index
  • All times are GMT
Powered by phpBB © 2001, 2005 phpBB Group


Hosted by NSR250dotNET © 2008 NSR250dotNET