foxmcscrooge wrote:Hi Econo,

23 is a spring washer so I doubt you can make it.
7 is a collar/spacer that slides over the axle; not a washer. Without it, your wheel will move around and probably bind up between the bearing carrier and part #5. I'd like to help but it would mean pulling apart my bike which I'm not likely to do anytime soon as it's all running perfect!

Cheers
Jim

Hi Jim!

thanks for the response.

at the moment #23 is sorted. i purchased a spring collar similar in size to the axle. it seems to be working just fine as i believe its function is only to keep the big bolt tight, right?

#7, however, i seem to be not using it. the sprocket bolts are incredibly close from rubbing the bearing holder, but it clears it.
i'm also in doubt that this setup will work ideally. i'm about the machine the said collar but a bit unsure on how thick it needs to be.
i guess 2mm will do? just enough so it clears the bearing holder and the chain remains inline, yes?

i guess i need to be more careful on where do i put things around,.. oh well..