Best way is to remove the nut **CAUTION -- LHT** holding the pulley on to the RC Valve shaft, and then simply flip the pully around (as if you were turning something inside-out).

Make sure you pay special attention to the order of the washers behind the nut. The washers/nut are (a) special, and (b) no longer available, so make sure you wire/cable-tie the bits together, and put them somewhere safe!

** AGAIN ** The nut holding the pulley on is left-hand-thread.
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!