Brake fluid level

**Sun Jun 21, 2015 12:43 pm » Post: #1 » Download Post**

Hi guys

When filling the reservoir do I fill to the correct level and then fold the rubber boot inside itself before fitting and then top cap on?
The rubber is quite big in length so brings the fluid up to over flowing the reservoir.
Some reservoirs have a rubber that is straight across so isn't an issue.
My bike is an mc16.
Thanks in advance.

Daz
_________________
stink wheels forever.

**Sun Jun 21, 2015 8:53 pm » Post: #2 » Download Post**

The level should be at the upper mark with the rubber diaphragm fitted.

It might sound obvious, but just in case, sometimes the diaphragm can be "sucked" inside out if the fluid or pads run low, so make sure it's fitted correctly.
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!

**Mon Jun 22, 2015 6:42 pm » Post: #3 » Download Post**

Thanks for reply Andy
The diaphramn is quite deep so I presume I fill reservoir to low mark and when diaphramn is fitted it brings level up to top mark?
Cheers
Daz
_________________
stink wheels forever.

**Mon Jun 22, 2015 11:14 pm » Post: #4 » Download Post**

That's pretty much the size of it! Smile

_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!

**Wed Jun 24, 2015 5:27 am » Post: #5 » Download Post**

Thank you

_________________
stink wheels forever.