Hi everyone

is there anyone who can give me total length of rear wheel axle (length under the head), head thickness and nut thickness ?

thanks

OK Tex, just for you:

Yesterday afternoon, I travelled 360km and purchased a 1992/3 MC21 SE for NZ$2,000.
I got up early this morning and extracted the rear axle.
I then cleaned it and measured it up and drew up the pretty picture attached.


Also, the nut is 18.2mm thick.

Hows that for service?
_________________
[color=#808080][size=9]Yes,.. I too know how to waste Time and Money,...

Heya Tuckerbag

Nice pic.
I saw that bike on trademe, if it's the same one?
Must be nice to get a complete bike rather then a pile of cardboard boxes and plastics.
I might be interested in the spare frame. I have a set of footpeg brackets somewhere, i think.

Yeah Dannyvirk, I am sure we are talking about the same bike.
It will be a few weeks before I know what bits I need and what I am going to be doing with the spare frame.
But in any case I will keep you in mind. We may be able to swap a few bits to each others benefit.

I am not expecting to have this bike completed in any great hurry.
Possibly a 1 to 3 year mission? Possibly it will end up as a 300cc machine, just for the hell of it?
I ran out of things in the shed to tinker away at, so I had to buy something.
_________________
[color=#808080][size=9]Yes,.. I too know how to waste Time and Money,...

TuckerBag wrote:OK Tex, just for you:

Yesterday afternoon, I travelled 360km and purchased a 1992/3 MC21 SE for NZ$2,000.
I got up early this morning and extracted the rear axle.
I then cleaned it and measured it up and drew up the pretty picture attached.

Also, the nut is 18.2mm thick.

Hows that for service?

Not so bad !!

THANK YOU VERY MUCH

Admin: Quoted "image" removed to save bandwith for slower/mobile connections.