I have a mc21 with tyga pipes but no rear support for the cans. Does anyone know if the original hangers fit or if there's anything that does? They seem far too wobbly for my liking.

You're best off making some clamps from some 1.5mm alloy sheet. You want the stays and brackets about 25mm wide.

The silencers DEFINITELY want bracing, or the chambers will almost certainly crack.

You can just pick up the OEM mounting points on the subframe.



I'd also advise making the "loops" for the silencers a little larger so you can slip a thin rubber "gasket" in.
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!

Thanks for the reply. The loops tyga sell so not a problem there, just have to find the mounting points and make some hangers.

Thanks again.

Hi Andy
I hope all is well with you,
I almost forgot about your little gem, That is one decent paint scheme, I wish I had bought Les.s Noodle when he sold it,
Have you any plans for getting it back in action ?

All the best,
jonmac
_________________
John

I hope to start on it later this year, John. Been rather busy for the start of the year with the new job.
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!