Hi guys does anyone know if either of these are the original Paddock stands that Honda used for the MC28. thanks

https://page.auctions.yahoo.co.jp/jp/auction/v715650524

https://page.auctions.yahoo.co.jp/jp/auction/w354126386
_________________
John 3:7

They both look very similar except for the colour, but they do look very Honda, very much like the genuine Honda one I had fir my RC30, from memory that had a large nut on the outside that you turned to get the inner spigot to grip on the inside of the hub, if the bore is the same, I wouldn't be surprised if they were the same stand, maybe even for the NC30 as well.
_________________
Proud Father of , 05 ktm 400exc supermoto 2018 honda crf rx supermoto

Thanks for the reply Les. From pictures i seen I think they are the same as the NSR paddock stands but I wasnt sure. Hopefully someone here has one and can confirm

Pretty sure all the [single nut] Pro-Arm hubs are the same ID. I don't recall needing to draw up different HRC-style conversion parts for any of them... one size fits all, as they say!

I think RC30, RC45, NC30, NC35, and MC28 are all the same. (The all differ in width though, of course!)
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!

Not sure I would take this as gospel but Demon Tweeks has a stand:
https://www.demon-tweeks.com/uk/warrior-single-sided-paddock-stand-319613/

Take a look at pin G & pin I, both listed for "various Honda"...maybe there is some variation.

Could you get an adaptor turned up if you get one of those stands back and its wrong? Or Maybe ask the sellers for the pin measurement?