Hi fellows, so I have a mc21 which doesn't have a gear position sensor, the female 6 pin g.p.s plug to PGM unit is just dangling there. But the bike seems to run normally without it.

So I was wondering if I could keep it deleted like that, or is there anything bad without the gear position sensor in place? Would the wire splice derestriction bypass the sensor and make it unnecessary?
Thanks a lot for any help!

To be honest, I'd want the GPS in place. The PGM-III is actually incredibly intelligent for a system designed almost 35 years ago, and absolutely does adjust a lot depending on which gear you are in. It's far more sophisticated than just TPS/GPS/RPM too, so if you can source on, I would definitely replace it.

There's one on Yahoo! Auctions right now.

https://www.jauce.com/auction/j1051650153
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!

Thank you so much Andy! I will definitely get one then.

Honestly worth it.
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!