When running open carbs (pod filters) do I leave this 3 way piece open to atmosphere? Or do I do something else?
_________________
John 3:7

http://nsr250.net/forums/members/nsr250r_manual_mc21_hrc/index.php#p=8

You delete all of that!
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!

Thanks Andy. It is talking about removing and replacing with parts from a kit but I have no idea what comes in the kit. I assume its the HRC kit.

long story short it doesn't make much sense to me lol

Delete the pipe that goes from the X-piece to the white 3-way joint (that plugs into the underside of the airbox), and the pipe that goes from the white 3-way joint to the air correction solenoid block. Leave that port on the solenoid open to air.

Replace the X-piece and the Y-piece with the HRC kit parts, or press the jets out of the standard parts and fit the T2R jets as shown.

Leave the jet in the X-piece open to air too.
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!