Torque Spec's?

**Fri May 12, 2006 2:44 pm » Post: #1 » Download Post**

I can't seem to find the torque spec for the intake boot bolts anywhere. Anyone know or can point me in the right direction? Thanks for the help.
_________________
To much HP is barely adequate!

**Fri May 12, 2006 4:06 pm » Post: #2 » Download Post**

Being a 6 mm bolt, it's normal torque setting is 0.8-1.2 kg-m.

For these bolts I generally don't use an actual torque setting and just expect it to be good.

I actually set the bolts while doing a leak down and make sure they are set so nothing leaks. This you will find is good to do if the intake boot is warped.
_________________
Charles Gallant

**Sat May 13, 2006 4:51 am » Post: #3 » Download Post**

Thanks Charles that helps out alot.
_________________
To much HP is barely adequate!