Just wondering what the rear wheel rim width is on various s/sided swingarms on Honda bikes:

NSR250/MC28?
VFR400/NC30?
RVF400/NC35?
VFR800

Specifically I am looking for a swingarm that would have a 5.0 rear rim.

FWIW, I have a racing supermotard with Marchesini 5.0x17 on my Service Honda CR500AF

Keith Walker
_________________
Service Honda CR500AF Supermoto!

RC30 runs 5.5" on the stock arm or up to 6" on the factory arm (or in a stock arm with a 180 rear).

RC45 runs a 6" stock but will also run a 5.5" or a 6.25" with the factory arm
_________________
If I have to take the carbs off once more...

4.5 on all the 250/400 variants, 18" rear for the NC30, 17" for the MC28/NC35
_________________
Please do not PM me technical questions, if you can't find it on the Forum start a thread

Thanks for the replies!

I guess I was looking for a 5.0 rear rim as that would match what is on my CR500 right now. I don't know if I could fit a 5.5.

1/4 inch closer to the chain if the swingarm is centered. It may depend on tire size, but I am close already with a 5.0.

If I could find a plated/titled/street legal 250 or 400 in the states, what a treat that would be!!!

Keith Walker
_________________
Service Honda CR500AF Supermoto!

What is the following on the MC28 swingarm?

Pivot width: ? mm
Pivot diameter: ? mm

Thanks, Keith Walker
_________________
Service Honda CR500AF Supermoto!

Don't forget the RC30 and NC30 both ran a 18" rear wheel.
_________________
james
Its not how fast you go...Its how you go fast.
MC21 Rothmans
RS250
RC31
CRF250X
748R
Porsche (many)
http://members.rennlist.com/j911brick/rennlist3_002.htm