hi there i ve just rebuilt and refitted my engine to my nsr(mc16) and although it purrs like a kitten now the servo for the rc valve does not seem to move at all.
What rev range should it begin to move at? and is ther a way of getting them to go into setting mode like the rgv's?

regards
liam

when I rebuilt mine jeff350lc sent me a some scanned pages from the honda manual. pm me your e-mail address and I will forward them on to you.
the servo should open fully at 2000rpm and close at 3000 to allow you to set the cables and then start to open again about 7000.
_________________
it's a name, not a condition