I have oil seeping into the dry clutch. Not much but enough for it to come from the small square mesh at the bottom of the cover and spray the right chamber and belly pan.
It's not the O ring on the push rod so Im changing the oil seal on the engine casing.
Is It big job with any pitfalls or shortcuts that anyone can give me advice on?
Very grateful for any advice,
Mal. _________________ if it had a tail - it would wag
Not a big job Mal, but the side casing (and therefore clutch assembly) needs to come off to replace the main transmission seal.
It all comes apart very easily (you'll need a holding tool for the clutch hub), and is pretty self-explanatory when you get in there.
Don't over-torque the pressure plate bolts on reassembly, as you have a good chance of sheering the posts off! I've seen plenty of NSR hubs/clutches with a spring missing! _________________ Andy.
NSR-WORLD.COM
Please keep all responses to Forum posts on the Forum so that others may benefit.
Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.
You want to do it sooner rather than later, or you will be adding the cost of a set of clutch plates to the list of parts too! _________________ Andy.
NSR-WORLD.COM
Please keep all responses to Forum posts on the Forum so that others may benefit.
Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You cannot download files in this forum