PGM4 with HRC030 card Eror2?

**Fri Feb 06, 2009 7:26 pm » Post: #1 » Download Post**

Hello I just installed a pgm4 with a HRC030 card and did the wire splice as told on the Tyga website. But when I plug in the card after 30 seconds Err2 begins to flash. But I tested the motor and it runs very well. What can this be?

**Sat Feb 07, 2009 10:59 am » Post: #2 » Download Post**

I did a little research on the PGM4 and I have seen that there is had been some repair in my PGM4. But I think it is not done very good. I am going to try to fix it.

**Sat Feb 07, 2009 7:06 pm » Post: #3 » Download Post**

Err2 is an error with the RC valve motor, either not plugged in or can't get a response.

Take care, mine melted the PGM soon after it started saying that.
_________________
Please do not PM me technical questions, if you can't find it on the Forum start a thread