I removed the sensors(not unplugged, just nicely cleaned), one was nice n filthy . Could have sworn there was a 1.5-1.8mm ish gap between them and the flywheel rises

Reinstalled to find only .7mm gap now, like wtf. Im sure id like minimum 1 mm atleast.. Any issues here i should be weary of?

Funny thing is, the sensors seem to be seated in 1 and 1 only position...
_________________

The mounting plates are shouldered on the stock pickups, so they can only fit where they fit!
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!

No probs, just checkn. If any one can let me know what their feeler guage says, that'd be cool, maybe even a pic or 2
_________________

Im still looking for a comfortable sensor gap, minimum clearance etc. Has anyone measured there gaps recently?
_________________

Just measured mine at 0.75 & 0.80mm. The only thing to worry about is if the flywheel touches the pickup. If you have a gap and they're not touching, you're good to go. Keep the pickups clean and free of those little filings that magnets like so much.

Kubira wrote:Im still looking for a comfortable sensor gap, minimum clearance etc. Has anyone measured there gaps recently?

Why would you measure them? You can't alter them.

They are what they are, they're fixed like that.
_________________
Please do not PM me technical questions, if you can't find it on the Forum start a thread

they can be filed down, and apparently there are alternaste ones available so ive seen
_________________