mc18 f3 shock linkage

**Mon Nov 02, 2009 5:40 am » Post: #1 » Download Post**

Hi Guys
I am going to get the f3 shock linkage made up (lazer cut) I need to know what size holes they need and the thickness of the plates does anyone know ?
Cheers Shane

**Mon Nov 02, 2009 4:26 pm » Post: #2 » Download Post**

This is a joke question, right?

Er, how about plates the same thickness as stock, and the holes the same size! Rolling Eyes

_________________

There`s no cure for stupidity… but with the endless supply of stupid people around me, I must be close to finding it!

The Lizard tells it like it is!

Read - Learn - Post... not - Post - Learn - Edit!

Vampire?

**Mon Nov 02, 2009 4:42 pm » Post: #3 » Download Post**

if someone doesn't have the stock linkage plates, it's hard to measure them.

Sorry don't have the details your looking for, I am sure Andy has the details, Andy?

Of course there is this page... not sure how different the F3 shock is from stock...
http://tech.nsr-world.com/nsr/mc18/f3-rear-suspension/

**Mon Nov 02, 2009 5:08 pm » Post: #4 » Download Post**

NSR-lizard wrote:This is a joke question, right?

Er, how about plates the same thickness as stock, and the holes the same size!

Yes could measure original ones but thought someone here might already know so i did not have to pull bike apart to measure just to have to put it back together again

**Tue Nov 03, 2009 3:21 pm » Post: #5 » Download Post**

Parts manual says bolts are M10.
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!