Offset flywheel key problem

**Sun Jul 18, 2010 11:45 am » Post: #1 » Download Post**

Hi
i have a offset flywheel key but it won't fit inside the cutout in the crank .
If i grind it , will the offset degree change ?
What should i do ?

Thanks , Neal

**Sun Jul 18, 2010 1:15 pm » Post: #2 » Download Post**

Yes it will either advance or retard depending which side you grid it.
_________________
If I have to take the carbs off once more...

**Sun Jul 18, 2010 1:15 pm » Post: #3 » Download Post**

Only if you grind it on one side!

Not the part for the job then?!
_________________

There`s no cure for stupidity… but with the endless supply of stupid people around me, I must be close to finding it!

The Lizard tells it like it is!

Read - Learn - Post... not - Post - Learn - Edit!

Vampire?

**Sun Jul 18, 2010 1:17 pm » Post: #4 » Download Post**

Requires a nice adjustable PGM-II and HRC ign system by the sounds of it.
_________________
If I have to take the carbs off once more...

**Sun Jul 18, 2010 2:04 pm » Post: #5 » Download Post**

Talking of flywheels Steve....... Wink

_________________
Please do not PM me technical questions, if you can't find it on the Forum start a thread

**Sun Jul 18, 2010 2:56 pm » Post: #6 » Download Post**

Yours is done Wink

_________________
If I have to take the carbs off once more...

**Sun Jul 18, 2010 6:00 pm » Post: #7 » Download Post**

Was this one of the TYGA keys? Bought a couple to try out on mine..
_________________
More **** two strokes than you can shake a **** stick at.

**Sun Jul 18, 2010 6:01 pm » Post: #8 » Download Post**

i have a fancy pgmii on the bike , when i look at the plugs they are'nt burning back . i bought some offset keys from Tyga to experiment but no luck Crying or Very sad

I could be interested in a beter pgm system , whats next ?