My rc servo are on HI all the time. If i turn it to low by my hand it goes to HI when I turn key on. No difference if I pull out tps contact. But, if I kick the bike the servo goes to middle and if I give it full throttle when I kick, it goes to LO!!??
Bike is hard to run when cold. It starts with choke, but if I give it throttle it sounds like a cow and dies
If i let it warm up a bit on idle and then raaarly gives it throttle "blipping the throttle" It will run. When its really warmed up its no problem. Just weak in the lower rpm.
Kind regards
Micke