I have a weird problem.
My rc servo are on HI all the time. If i turn it to low by my hand it goes to HI when I turn key on. No difference if I pull out tps contact. But, if I kick the bike the servo goes to middle and if I give it full throttle when I kick, it goes to LO!!??
Bike is hard to run when cold. It starts with choke, but if I give it throttle it sounds like a cow and dies If i let it warm up a bit on idle and then raaarly gives it throttle "blipping the throttle" It will run. When its really warmed up its no problem. Just weak in the lower rpm.
Have checked my valves. Everything is fine, but my servo goes from Hi to Lo. So if i start the bike it has open valves and if i give throttle it close the valve
This is my first 2 stroker (road bike) so I don't now if it have run perfect. But it run way better then now. Don't know if its the original servo. Can a fault tps made this problem?
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You cannot download files in this forum