Hi All

Trying to avoid Andy & Stephen banning me from ever PM'ing them again with all my questions, so posting it.

How does a GPS switch function to send it's signal to the PGM-III on the MC21.

I have an MC18 switch in my bike and there is only a single wire for neutral on it.
What I need to know more is if I can wire the GPS plug to the PGM-III independent of the switch or is it integral to the function.

Thanx to All
Garth

P.S. Alwyn, how come no reply, boet? I have WingDing(my stroker) stuck in my garage with part of an HRC harness and delimiter mounted with a few bits still dangling for lack of knowledge. Give me a scream sometime.

This should help you a little:

Delimited MC21 wiring diagram.

You'll see 4th, 5th, and 6th spliceed into 3rd (and earthed/grounded); just splice 1st and 2nd in too... or get a GPS switch! Someone must have one in a set of dead cases somewhere!
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!

It definitely helps, Andy.

Tons of gratitude. When I recover from buying the bits from you I pledge a donation to the site!

Thanx
Garth

Who's got all the crank cases? lol
_________________
If I have to take the carbs off once more...

I think I know where there are about 5 sets... don't I Steve?!

I'm sure I know where there are another 2 sets...

I definitely know where there is 1 set about to go to the machine shop... eh Matt?!
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!

Errrrrrr