Need a mc18/2j splined RC valve shaft.
Anybody got or can direct me to somewhere I can get the splined shaft ( NOT the square shaft) for the front cyl. I have several and am doing this one to sell ( for racing only). Somebody thought at some stage that snapping off the thread end was a good idea. I wonder how they did that then!!!!!!!
Need one so I can proceed to get it up to scratch. It runs easily and starts easily even without cleaning the carbs , which I will do when I can get a complete shaft.
Any help would be greatly appreciated but one in Australia would be easiest, but anywhere in the world if it isn't ridiculously overpriced.
Second hand will be fine and I don't really need the valves as these are in good condition.
This will help get an NSR back into circulation , even if only on the track
_________________
NSR250 mc18/2 to be fixed and sold
NSR250 mc18/4 ( two of) to be fixed and sold
NSR250 mc21 (two of) One now racing /other to be race backup)
Sachs 150 bucket
Cagiva 650 Raptor

I forgot to add . I think the shaft is the same as the mc16
_________________
NSR250 mc18/2 to be fixed and sold
NSR250 mc18/4 ( two of) to be fixed and sold
NSR250 mc21 (two of) One now racing /other to be race backup)
Sachs 150 bucket
Cagiva 650 Raptor

I MAY have a spare one will check and see.

That would be brilliant. let me know please if you have. Only really need the shaft and nut, but whole lot ( shaft, clip, seal, valves etc.) would be good too
_________________
NSR250 mc18/2 to be fixed and sold
NSR250 mc18/4 ( two of) to be fixed and sold
NSR250 mc21 (two of) One now racing /other to be race backup)
Sachs 150 bucket
Cagiva 650 Raptor

I'll check tonight, been away for a couple of days

Sorry for the delay, I do have a spare shaft, no nut or bearing tho. pm your address and I flick it your way.